Otto Bock Genium X3 3B5-3 Instructions For Use Manual page 53

Error while charging the product
LED on Status LED
power sup­ on battery
ply charger
Status LED Charging status indicat­
The LED
ring is lit in
weak purple
The LED
ring is lit up
yellow
The LED
ring is lit up
green
The LED
ring is flash­
ing red
Genium X3 3B5-3/3B5-3=ST
Error
Country-specific plug adapter not fully
engaged on power supply
Non-functional socket
Defective power supply
No connection between battery charger
and power supply
Defective battery charger
or (5 LEDs)
No LED is lit
LED 2 and 4 are lit up
LED 1, 3 and 5 are lit up
LED 3 is lit up
Resolution
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Check socket with another electric appli­
ance.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Check whether the charging cable plug is
fully engaged on the battery charger.
The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
Error
Distance between battery
charger and receiver of the
charging unit on the pros­
thesis too great. If the dis­
tance is more than 2 mm,
the prosthesis cannot be
charged.
Charger excess temperat­
ure
Excessively high or low
temperature of the pros­
thesis
The prosthesis is not being
charged
Distance between battery
charger and receiver of the
charging unit too great.
The battery charger
functional but not connec­
ted to the receiver, or the
distance between the bat­
tery charger and receiver
of the charging unit is too
great.
The prosthesis is not being
charged
Defective battery charger.
Appendices
Resolution
Reduce distance between
battery charger and receiver
of the charging unit.
Check whether the spe­
cified ambient conditions for
charging the battery are met
(see Page 48).
Connection may
improved by reducing the
distance between the char­
ger and receiver of the char­
ging unit.
is Connect the battery charger
or reduce the distance
between the charger and
the receiver of the charging
unit on the prosthesis.
Reset the error by discon­
necting and connecting the
power supply.
If the error persists, the bat­
tery charger and power sup­
ply must be inspected by an
authorised Ottobock Ser­
vice Center.
be
53