Shielding
UL temperature rating
Voltage
Listing
ZS sensor overview
ZS Sensors are thermistor-based temperature sensors that may optionally sense humidity, CO
Sensors are wired to the Rnet port on most Carrier controllers.
REQUIREMENTS
•
A v6.0 or later i-Vu® system
•
v6-xx-xxx or later controller drivers
You can use the following ZS sensors:
•
ZS Standard
•
ZS Plus
•
ZS Pro
•
ZS Pro-F
An Rnet can consist of the following devices wired in a daisy-chain or star configuration:
•
Up to 15 ZS sensors if the controller contains multiple control programs for the sensors
•
One Equipment Touch
•
You cannot have SPT sensors and ZS sensors on the same Rnet.
For basic user instructions, see the ZS Sensor User Guide. For detailed installation instructions, see the ZS
Sensors Installation Guide.
SPT sensor overview
The SPT sensor is a wall-mounted space temperature sensor that monitors room temperature.
The MPC Open XP supports the following:
•
SPT Standard
•
SPT Plus
•
SPT Pro
•
SPT Pro Plus
MPC Open XP
MPC Open XP IO48/816
Installation and Start-up Guide
If shielded, Aluminum/Mylar shield (100% coverage) with TC drain wire, terminated
at controller
32–167°F (0–75°C)
300 Vac, power limited
UL: NEC CL2P, or better
Carrier Proprietary and Confidential
21
Installing the MPC Open XP
, or VOC. ZS
2
CARRIER CORPORATION ©2017
All rights reserved