Removing A Ssd Storage Drive - IBM BladeCenter HS22V Installation And User Manual

11. Install the cover onto the blade server (see "Closing the blade server cover" on
12. Install the blade server into the BladeCenter unit (see "Installing the blade
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 49.

Removing a SSD storage drive

Use this information to remove an SSD storage drive.
The blade server has two SSD storage bays. To remove an SSD storage drive,
complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. Remove the blade server from the BladeCenter unit (see "Removing the blade
3. Remove the cover from the blade server (see "Removing the blade server
4. If an expansion unit is installed, remove the expansion unit (see "Removing an
5. Remove the front bezel from the blade server (see "Removing the bezel
6. Locate the SSD storage drive you want to remove; then, press the release
7. Use your fingers to pull the SSD drive out of the SSD connector.
26
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide
page 50).
server in a BladeCenter unit" on page 51).
page 19.
server from the BladeCenter unit" on page 21).
cover" on page 22).
optional expansion unit" on page 24).
assembly" on page 28).
Attention: When you remove an SSD drive, use a felt-tip pen to write which
SSD connector the drive was removed from on the drive label. Installing an
SSD drive into a different SSD connector can damage the RAID configuration.
Note: If there is an SSD drive in SSD connector 1, it must be removed before
you can remove the SSD drive in SSD connector 0. SSD connector 1 is on top of
SSD connector 0.
button to eject the SSD drive (see "Blade server connectors" on page 18).
SSD Storage drive