Voice Mail Setup
Basic IntraMail and UltraMail Programming
IntraMail and UltraMail built-in Voice Mail systems automatically set up without any required programming.
Basic External Voice Mail Programming
Prior to programming, follow the instructions that came with your external Voice Mail and connect the Voice
Mail to your system. If you are using the DS1000 PFT/MDM port for a Power Failure Telephone or
Modem Cut-through, do not use extension 316 for external Voice Mail.
The system provides a predefined set of Voice Mail station numbers (201-208), which have a predefined set
of corresponding Voice Mail extension numbers (500-507). In addition, the Voice Mail extension numbers
are already designated as Voice Mail ports and assigned to a predefined UCD Hunting Group (with 700 as
the master number).
The basic external Voice Mail programming is divided into three parts:
●
Part I: Enable External Voice Mail
●
Part II: Assign the external Voice Mail ports to the Voice Mail station numbers.
●
Part III: Program the external Voice Mail system.
Part 1: Enable External Voice Mail
1.
Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2.
Enter
8001:V-MAIL SETUP
V-MAIL TYPE?NONE
3.
Enter
8001:V-MAIL SETUP
V-MAIL TYPE?EXTERNAL
4.
Press
Part II: Assign the External Voice Mail Ports to the Voice Mail Station Numbers
(DS2000)
For Analog Voice Mail (such as analog VANGARD and NVM-2e)
1.
Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2.
Enter
9902:STATION CARDS
SLOT?
3.
Enter the slot number (2-8) that contains the ASTU PCB to which your analog Voice Mail is connected
+
HOLD
9902:SLOT:n:nASTU
V-RMV/P-PORTS/X-SWAP
4.
Enter
9902:SLOT:n:nASTU
PORT:nn STATION:nnn
5.
Press
DS1000/2000 Quick Setup Guide
8001
+
HOLD
. You see:
E
(3) +
HOLD
. You see:
CONF
to exit program 8001.
+
. You see:
9902
HOLD
. You see:
P
(7). You see:
VOL Up
until you select the first (lowest numbered) port to which your Voice Mail is connected.
Section 1: Start-up Programming
Section 1: Start-up Programming ◆ 1-11
1