Remote Setup - Magnum Energy ME-ARC Owner's Manual

http://www.wholesalesolar.com/inverter_systems.html

01 Remote Setup

01 Remote Setup - The following menus 01A-01D are used to set up the
remote screen and clock.
• 01A Set Clock: The ME-ARC contains a real time clock that must be set
for proper operation of some features. These features are: 02C AC In-Time,
04B Gen Run Time, 04G Quiet Time, 04H Gen Exercise and 04 Fault History
under the TECH button.
Info: The clock obtains power from the inverter and will reset if the
ME-ARC is disconnected from the inverter.
Set Clock Hour - Set the hour of the day between 1-12, AM-PM will be
set later.
Set Clock Minute - Set the minute between 0-59.
Set Clock AM-PM - Set AM or PM.
• 01B Contrast - Used to adjust the contrast of the LCD screen for the
best looking display, based on the current lighting conditions and viewing
angle. Set the Contrast from 0-100%.
Default settings: Contrast = 100%
• 01C Backlight - Used to adjust the brightness of the LCD screen
backlight for the best looking display, based on the current lighting conditions
and viewing angle. Set the Backlight from 0-100%.
Default settings: Brightness = 50%
• 01D Power Save - This setting allows you to turn off the Power Save™
feature or select the time (from Off to 60 minutes) that determines how
often the display goes into Power Save mode.
Default setting: PwrSave = 15min.
What is the Power Save feature? The Power Save feature causes the LCD
backlight and LED's on the remote display to turn off to conserve energy.
The remote goes into Power Save mode if there hasn't been a button press
or fault message for a period of time (this time is determined by the SETUP:
01D Power Save setting). Whenever the remote goes into the Power Save
mode, the LCD backlight and LED's can be reactivated by pressing any menu
button. If you have a fault during the Power Save mode, the LCD backlight
and Fault LED will come on and stay on as long as the fault is present.
Info: If you want the LCD backlight and LED's to always be on,
you will need to turn the Power Save feature off by selecting Power
Save = Off.
• 01E Temp Display - The temperature display is used to select whether to
display temperatures in Fahrenheit or Celsius. When selecting either Fahrenheit
or Celsius, the following menus will appear with this selection; 03D AGS Temp,
04E Gen Run Temp, and 01 Temperatures under the TECH button.
Default Setting: Fahrenheit
© 2010 Magnum Energy, Inc.
3.0 Setup
19