Magnum Energy ME-ARC Owner's Manual page 21

http://www.wholesalesolar.com/inverter_systems.html
• 04B SOC: This display is the best way to monitor the actual state of
the battery. The read only display shows the State Of charge (SOC) for
the connected battery bank. The SOC represents the condition of the
battery as a percentage of the available capacity left in the battery.
Range is 0% to 100%, where 100% represents a fully charged battery
and 0% means the battery is completely discharged.
• 04C DC Volts - BMK: This meter displays the real-time battery voltage
from 07.00 to 70.00 volts (± 0.02 volts).
• 04D DC Amps - BMK: This meter displays the real-time charge current
(amps into the battery) or discharge current (amps out of the battery).
Charging is shown as a positive (+) number and discharging is shown
as a negative (-) number. The range is from ±0.1 to 999 amps, with a
1.0% accuracy.
•
04E AH In/Out: This meter displays the Ampere-Hours returned to
or removed from the battery. When this value is positive, it represents
amp-hours returned to the battery during any subsequent charging. A
negative value represents amp-hours removed from a full battery. Its
range is ±32768 AH.
• O4F Resetable AH: This meter displays the total amp-hours removed
from the battery since it was last reset. This display can be used as
a battery load indicator; to help determine and monitor the battery
load consumption. Its range is 0 to 65,535.0 amp-hours (0.1 amp hour
resolution).
• 04G Total AH Out: Total Amp-Hours Removed; this meter displays
the total amp hours removed from the battery since the Sense Module
was fi rst connected. This display can be used as a battery service life
indicator. The value is displayed in 0.1k [or 100 amp-hours ("k" equals
1000)] resolution up to a maximum of 6,553.5k amp-hours (6,553,500
amp-hours). The displayed number resets to 0.0k when the Sense
Module is disconnected from power.
• 04H Minimum VDC: This menu displays the lowest battery voltage
since the last reset. The voltage shown on the display is averaged each
second and is helpful when troubleshooting or detecting an over-dis-
charge condition.
• 04I Maximum VDC: This menu displays the highest battery voltage
since the last reset. The voltage shown on the display is averaged each
second, this allows you to check your charging system (battery charger,
charge controller, etc.), to ensure the charging voltage has been attained.
This display is also helpful when troubleshooting or detecting if an over-
charge condition has occurred.
© 2010 Magnum Energy, Inc.
3.0 Setup
17