2.0 Installation
2.2
Installation Procedure
Select an appropriate location to install the ME-MR remote control. Allow
ample room to access the remote's buttons and to view the LEDs. Ensure
the viewing angle of the display is appropriate. You can either fl ush mount
(concealing the connection) or surface mount the remote.
2.2.1
Flush Mounting the Remote
After selecting the desired location for fl ush mounting the remote, cut out
a square mounting hole measuring 2
remote into the cutout, and then use the remote to mark and pre-drill two
⅛
" holes for the two supplied #6 x
(6.03 cm)
(2.86 cm)
Side view
Figu r e 2 - 1 , Cu t - Ou t D im e n sion s for Flu sh M ou n t e d Re m ot e
2.2.2
Surface Mounting the Remote using the Bezel
After selecting the location for surface mounting the remote, use the supplied
bezel as a template to mark the mounting holes. Mark and pre-drill four ⅛"
holes (see Figure 2-2). Mount the bezel using the four #8 x ¾" screws.
Bezel front view
Figu r e 2 - 2 , Be ze l D im e n sion s for Su r fa ce M ou n t e d Re m ot e
3
⅜
⅜
" x 2
" (see Figure 2-1). Place the
½
" Phillips fl at head mounting screws.
(6.83 cm)
(2.86 cm)
(6.03 cm)
Back view
Bezel side view
© 2020 Sensata Technologies
(4.1 cm)