Flush Mounting The Remote; Surface Mounting The Remote Using The Bezel; Figure 2-1, Cut-Out Dimensions For Flush Mounted Remote; Figure 2-2, Bezel Dimensions For Surface Mounted Remote - Magnum Energy ME-MR Owner's Manual

2.2.1

Flush Mounting the Remote

After selecting the desired location for fl ush mounting the remote, cut out
a square mounting hole measuring 2
remote into the cutout, and then use the remote to mark and pre-drill two
⅛
" holes for the two supplied #6 x
(6.03 cm)
(2.86 cm)
Side view

Figure 2-1, Cut-Out Dimensions for Flush Mounted Remote

2.2.2

Surface Mounting the Remote using the Bezel

After selecting the desired location for surface mounting the remote, use the
bezel (not supplied) as a template to mark the mounting holes. Mark and
⅛
pre-drill four " holes (see Figure 2-2). Mount the bezel using the four #6
¾
x " screws.
Bezel front view

Figure 2-2, Bezel Dimensions for Surface Mounted Remote

©2013 Magnum Energy, Inc.
⅜ ⅜
" x 2 " (see Figure 2-1). Place the
½
" Phillips fl at head mounting screws.
(2.86 cm)
Back view
Bezel side view
2.0 Installation
(6.83 cm)
(6.03 cm)
(2.86 cm)
3