Figure 3-14, Setup: 07 Power Save Selections; Figure 3-15, Setup: 08 Screen Setup Selections - Magnum Energy ME-RC Owner's Manual

3.0 Setup
• SETUP: 07 Power Save – This setting allows you to turn off the Power
Save feature, or to select a time (from 1 minute to 60 minutes) that
determines how often the display goes into Power Save mode.
Default setting: PwrSave = 15min
Range: OFF, 1-60 Minutes
SETUP
Rotate to
Status...
Press
07 Power Save

Figure 3-14, SETUP: 07 Power Save Selections

What is the Power Save feature? The Power Save feature causes the LCD
backlight and LEDs on the remote display to turn off to conserve energy. The
remote goes into Power Save mode if there hasn't been a button press or
fault message for a set period of time. Whenever the remote goes into Power
Save mode, the LCD backlight and LEDs can be reactivated by pressing any
menu button. During Power Save mode, the LCD backlight and Fault LED will
come on and stay on as long as a fault is detected.
If you want the LCD backlight and LEDs to always be on, you will need to
turn the Power Save feature off by selecting PwrSave = OFF.
• SETUP: 08 Screen Setup – Used to adjust the contrast of the LCD
screen and the backlight brightness for the best looking display based
on the current lighting conditions and viewing angle.
Default settings: Contrast = 100%; Brightness = 50%
Range: Contrast: 0-100%, Brightness: 0-100%
SETUP
Rotate to
Status...
Press
08 Screen Setup
Press to save
Brightness Range: 0-100% (increments by 10%)

Figure 3-15, SETUP: 08 Screen Setup Selections

27
Press to select
Range: OFF, 1-60 Mins
Press to select
Contrast Range: 0-100% (increments by 10%)
Status...
Brightness =50%
Rotate to
desired
selection:
©2013 Magnum Energy, Inc.
Rotate to
desired
selection: Press to save
Rotate to
desired
Press to save
selection: