Bezel Mount Installation Procedure; Figure 2-1, Remote Cutout Dimensions; Figure 2-2, Remote Bezel Dimensions - Magnum Energy ME-ARC Owner's Manual

Table of Contents

http://www.wholesalesolar.com/inverter_systems.html

2.4 Bezel Mount Installation Procedure

1. Select an appropriate location to install the remote control. Allow ample

room to access the remote's adjustment dial and to view the LEDs. Ensure

the viewing angle of the display is appropriate.

2. Refer to Figure 2-2 for mounting dimensions. Use the 3 1/4 x 5 1/4 dimen-

sions for mounting the bezel. Mount the remote to the bezel and run the cable

through the notch or out the back of the bezel for best mounting.

3. Run the remote cable between the remote and the inverter/charger. This

cable is a 4-wire, twisted-pair, telephony standard with RJ11 connectors on

each end. A standard telephone cable may be substituted if the provided

remote cable is not able to be used.

4. Connect the remote cable into the RJ11 "Remote" port (has blue label) on

the inverter/charger (see Figure 2-3).

5. Have the inverter connected to batteries, but ensure the inverter is off and

that no AC power is connected to the inverter.

1/4

C U T O U T T H IS

A R E A

(d ia g ra m n o t to sca le )

7/8

5 7 /8 in [148.6 mm]

5 1/4 in [133.35 mm]

4 3/8 in [110.5 mm]

2.0 Installation

Table of Contents

Me-arc50