7.
Immediately upon connecting the remote cable, all the LED's will come on
as the unit goes through a self-test. After the initial self-test completes,
text should appear with a system status message indicating the current
state of the inverter/charger. If not, please refer to the troubleshooting
section.
8.
The remote is ready for setup.
Info: All power to operate the remote control is provided by the
inverter/charger through the remote cable
M a g n u m In ve rte r
Figure 2-3, Remote Control Connections
©2009 Magnum Energy Inc.
Setup
R J1 1 C o n n e ctio n
R e m o te C a b le
R E M O T E P o rt (b lu e )
5