Software; Commands; I) Direct Command; Ii) Menu Options - Mecmesin MultiTest-x Series Operating Instructions Manual

operation can then be restored after the system has been re-set by twisting the
[Emergency Stop] button about 60º clockwise.

Software

Commands

There are four basic types of software instructions which can be entered via the
control panel:
i. A direct command
ii. Choosing a menu option
iii. Selecting an option from within a menu
iv. Typing in a value

i) Direct Command

A direct command is one to which the MultiTest-x system will attempt to respond
without delay. The direct commands are:
•
Pressing [Jog Up] to move the crosshead up
•
Pressing [Jog Dn] to move the crosshead down
•
Pressing [Start/ENT] to run the current test procedure
•
Pressing [Tare] to re-display the 'tare screen'
Direct commands can only be executed from the 'live test' screen (see [1], <1>
Procedure Menu).

ii) Menu Options

The system communicates with the operator by means of an LCD display consisting
of four lines with twenty characters per line.
Mecmesin MultiTest-x manual
10