Appendix 6: MultiTest-x Program Development Page 2
F.
Set the required tolerance limits using Set Limits [1], [3], [2], [2]
i)
ii)
iii)
iv)
v)
vi)
G.
i)
ii)
iii)
iv)
v)
can to '20 N' for the next 10 seconds
H.
Archiving the Data
Archive the data using the Print Menu [1], [2]
i)
ii)
iii)
iv)
NO
J.
FINISH
Set the Pass/Fail Limits
Enter the lower limit for the Peak result as 20N.
Enter the upper limit for the Peak result as 25N.
Enter the lower limit for the Minimum result as 15N. Press [Start/ENT]
Enter the upper limit of the Minimum result as 20N. Press [Start/ENT]
Enter the lower limit of the Average result as 18N.
Enter the upper limit for the Average result as 22N. Press [Start/ENT]
Run the Program
At the Main Menu screen press [1] until 'TUTORIAL-1' is displayed
Press [Stop/BK SP] to load 'TUTORIAL-1' and display the 'live screen'
Press [(-)/Tare] and [1] to set the load and displacement to zero
Press [Start/ENT] to run 'TUTORIAL-1'
Pull gently on the loadcell and try to keep the reading as close as you
Press [1] to download the test results to a PC or datalogger
Press [2] to download the XY Data to a PC or datalogger
Press [3] to download the Procedure 'TUTORIAL1' to a PC or datalogger
Press [4] to download calibration information to a PC or datalogger
Refine the Test
Press [Start/ENT]
Press [Start/ENT]
Press [Start/ENT]
I.
YES
A.
START
Need help?
Do you have a question about the MultiTest-x Series and is the answer not in the manual?