Software Setup - Mecmesin VortexPro Operating Manual

Motorised torque tester

Hide thumbs Also See for VortexPro:

software, hardware, and firmware properties. You can also review calibration data for the test system.

8.7

Software setup

A VectorPro license is required to run a VortexPro test stand and VectorPro software.

VectorPro test software is supplied on a USB key or can be downloaded online from:

https://downloads.vectorpro.cloud

The software installation file(s) should be copied to a location from where it can be run on the operator's

computer. Please do not connect the test stand until the installation has been completed.

Step 1

VectorPro software installation

Locate the download or installation folder and start the installation by double-clicking the

Vector.Installer.exe (executable file).

Vector.Installer.exe

Step 2

VectorPro software installation

Once open, click on the ' I nstall VectorPro

Step 3

VectorPro software installation

The VectorPro installer will install drivers necessary to complete the installation.

Install VectorPro' option.

Table of Contents