5] Install Defaults; 6] Diagnostics - Mecmesin MultiTest-x Series Operating Instructions Manual

Mecmesin MultiTest-x manual
Erase the current procedure name by pressing the [Stop/BK SP] key, then type in up
to 20 characters to give the first procedure a new name. To enter 'TEST-7' press the
[8] key twice, press the [3] key three times, press the [7] key five times, press the
[Tare] key once, then press the [7] key once. It will be necessary to wait two seconds
while the system accepts a character, before trying to enter the next character.
Pressing [Start/ENT] will store the new name for the first procedure; then a screen to
re-name the second procedure will be displayed...

[1], [4], [5] Install Defaults

If you have permission to enter this screen, type in the
appropriate password. Access to this screen would normally be limited to the
designated 'responsible person' associated with the particular MultiTest-x system,
typically the Quality Manager or Quality Laboratory Supervisor. (If the password is
entered incorrectly 'INVALID PASWORD' will be displayed, and the screen will
automatically re-set after a few seconds.) Pressing [Start/ENT], will display,
pressing [Start/ENT] again will reset all parameters to the original factory setting,
pressing [Stop/BK SP] will return to the Utilities Menu.

[1], [4], [6] Diagnostics

Choosing this option will display a screen looking similar to this,
34