Onecontrol App Auto Leveling; Onecontrol App Hitch Recognition - Lippert Components Ground Control TT Installation And Owner's Manual

OneControl App Auto Leveling

1. Prior to auto leveling, make sure the trailer is unhitched
from the tow vehicle and the tow vehicle is parked a safe
distance away from the trailer.
2. Power on the OneControl Touch Panel App.
3. Press the Leveling icon (Fig.39A).
4. Press AUTO LEVEL button (Fig.36K).
NOTE: Once the automatic leveling cycle has been started,
it is important that there is no movement in the trailer until
the leveling process is complete. Failure to remain still
during the leveling cycle could have a detrimental affect on
the performance of the leveling system.
NOTE: Sequence may vary slightly based on the height of
the trailer coupler prior to leveling.
5. When the Auto Level Sequence begins:
A. The system checks that the rear jacks are retracted.
B. The Power Tongue Jack may adjust depending on the
orientation of the trailer.
C. Front jacks will extend until movement of the trailer is
sensed.
D. The Power Tongue Jack will then retract.
E. The front jacks will extend/retract near level.
F. Rear jacks will extend and ground.
G. Trailer will level front-to-back and then side-to-side.
H. The auto leveling sequence will ground all jacks to
ensure all footpads are on the ground.
I. The auto leveling sequence is complete when the
OneControl App indicates, "Auto Level Success."
NOTE: If the AUTO LEVEL sequence does not perform
as described above, locate the OneControl Touch Panel
or use the OneControl App to place the system in Manual
Mode. Test that the jacks operate correctly by pushing
their corresponding buttons on the OneControl Touch
Panel or App; e.g., FRONT button operates only the
front jacks, etc. See OneControl Touch Panel Operation
or OneControl App Operation section.
lci1.com 574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)

OneControl App Hitch Recognition

1. Power on the OneControl Touch Panel App.
2. Press the Leveling icon (Fig.39A).
3. Press AUTO HITCH (Fig.36L).
A. Rear jacks will retract.
B. The Power Tongue Jack will extend to the ground.
C. Front leveling jacks will retract.
D. The tongue jack will then adjust the height of the front
of the trailer coupler to the point at which the AUTO
LEVEL button was most recently pressed.
4. Back the tow vehicle into position to align the tow vehicle
hitch and trailer coupler with each other.
5. Press RETRACT button, then press the FRONT button
to retract the tongue jack until the coupler sets into position
on top of the tow vehicle hitch.
6. Latch the tow vehicle hitch and connect any wires,
chains or sway control that may be equipped between the
tow vehicle and trailer.
7. Press the RETRACT button and then press and hold the
FRONT button until the Power Tongue Jack fully retracts.
NOTE: To utilize the Power Tongue Jack for the hitching
process, see the Power Tongue Jack Operation section.
27
CCD-0002700
TT
®
®
(3K-5K)
Rev: 03.02.21