Auto Level; Hitch Recognition - Lippert Components Ground Control TT Installation And Owner's Manual

9. Pull tow vehicle away and park at a safe distance.
NOTE: To utilize the Power Tongue Jack for the unhitching
process , see Power Tongue Jack Operation section.

Auto Level

1. Prior to auto leveling, make sure the trailer is unhitched
from the tow vehicle and the tow vehicle is parked a safe
distance away from the trailer.
2. Press both Up and Down Arrow buttons (Fig.31B and C) at
the same time if the green indicator LED is not on.
3. Press AUTO LEVEL button (Fig.31D).
NOTE: Once the automatic leveling cycle has been
started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process.
Failure to remain still during the leveling cycle could
have a detrimental affect on the performance of the
leveling system.
NOTE: Pressing any button during an auto leveling
sequence will abort the auto leveling cycle.
NOTE: Sequence may vary slightly based on the height
of the trailer coupler prior to leveling.
4. When the auto leveling sequence begins:
A. The system checks that the rear jacks are retracted.
B. The Power Tongue Jack may adjust depending on
the orientation of the trailer.
C. Front jacks will extend until movement of the trailer
is sensed.
D. The Power Tongue Jack will then retract.
E. The front jacks will extend/retract near level.
F. Rear jacks will extend and ground. The trailer will level
front-to-back, then side-to-side.
G. The auto leveling sequence will ground all jacks to
make sure all footpads are on the ground.
H. The auto leveling sequence is complete when the
indicator light turns solid green.
lci1.com 574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
NOTE: If the auto leveling sequence does not perform as
described above, locate the OneControl Touch Panel or
use the OneControl App to place the system in Manual
Mode. Test that the jacks operate correctly by pushing their
corresponding buttons on the OneControl Touch Panel or
App; e.g., FRONT button operates only the front jacks, etc.
See OneControl Touch Panel Operation or
OneControl App Operation section.

Hitch Recognition

1. To turn on the Auto Leveling Control Touch Pad, press
both Up and Down Arrow buttons (Fig.31B and C) at the
same time. The green indicator LED (Fig.31A) will turn on.
2. Press HITCH HEIGHT button (Fig.31E).
A. Rear jacks will retract.
B. The Power Tongue Jack will extend to the ground.
C. The front leveling jacks will retract.
D. The tongue jack will then adjust the height of the front
of the trailer coupler to the point at which the AUTO
LEVEL button was most recently pressed.
3. Back the tow vehicle into position to align the tow vehicle
hitch and trailer coupler with each other.
4. Press and hold the Down Arrow button to retract the
tongue jack until the coupler sets into position on top of the
tow vehicle hitch.
5. Latch the tow vehicle hitch and connect any wires,
chains or sway control that may be equipped between the
tow vehicle and trailer.
6. Press and hold the Down Arrow button until the Power
Tongue Jack is fully retracted.
NOTE: To utilize the Power Tongue Jack for the hitching
process, see Power Tongue Jack Operation section.
18
CCD-0002700
TT
®
®
(3K-5K)
Rev: 03.02.21