Lippert Components In-Wall Slide-Out Assembly Manual
  1. Manuals
  2. Brands
  3. Lippert Components Manuals
  4. Automobile Accessories
  5. In-Wall Slide-Out
  6. Assembly manual

Lippert Components In-Wall Slide-Out Assembly Manual

Shipped in box or tube
Hide thumbs Also See for In-Wall Slide-Out:
1
2
3
4
5
6

Advertisement

Table of Contents

In-Wall
Slide-Out
SHIPPED IN BOX OR TUBE
®
ASSEMBLY MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the In-Wall Slide-Out and is the answer not in the manual?

Questions and answers

Related Manuals for Lippert Components In-Wall Slide-Out

Summary of Contents for Lippert Components In-Wall Slide-Out

  • Page 1 In-Wall Slide-Out SHIPPED IN BOX OR TUBE ® ASSEMBLY MANUAL...
  • Page 2 Installing Shipping Angles System Information The Lippert Components, Inc. In-Wall® Slide-Out System can now be shipped disassembled at the large components level. This means that some assembly will be required prior to the installation of the In-Wall® Slide-Out System onto the slide-out room. The following instructions are supplied as a guide to the proper assembly of the shipped components for the best possible functioning and operation of the In-Wall®...
  • Page 3 Procedure The top and bottom gear racks on each side of the In-Wall Slide-Out System are connected by a torque shaft that runs from the upper bearing block to the lower bearing block. The bearing blocks and torque shaft are mounted inside of the column.
  • Page 4 Once both gear racks are engaged, use a tape measure and measure from the column to the end of each gear rack. The measurements must be the same to ensure that the slide room will be timed correctly. Repeat steps 1-8 for the other In-Wall Slide-Out assembly. Fig. 5 Page 4 Rev: 05.12.21...
  • Page 5 Installing Shipping Angles On the exterior side of the H-column, place a shipping angle (Fig. 6A) at both ends of the upper and lower gear racks (Fig. 6B). See Fig. 6 details for orientation of the shipping angles on the gear racks. Align the pre-drilled holes in the shipping angle with the pre-drilled hole on the face of the notched end and the extruded hole on the end of the non-notched end.
  • Page 6 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”).  LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided.  Any unauthorized use shall void any applicable warranty. ...

Table of Contents