Manual Override; Power Tongue Jack Manual Override; C-Jacks Manual Override - Lippert Components Ground Control TT Installation And Owner's Manual

Manual Override

Power Tongue Jack Manual Override

1. Chock the tires of the trailer.
2. Make sure the footpad of the Power Tongue Jack is
pinned securely in place with the clevis pin and hairpin
cotter pin (Fig. 41A).
3. Remove the rubber plug (Fig. 42A) on top of the Power
Tongue Jack's gearbox to expose the manual drive shaft.
4. Insert the manual crank handle (Fig.43) into the manual
drive shaft.
5. Turn the crank handle counterclockwise to retract the
tongue jack or clockwise to extend the tongue jack.
6. Remove the crank handle (Fig.43).
7. Replace the rubber plug (Fig.42A).
NOTE: Make sure the leg (Fig.41B) of the Power Tongue
Jack is fully retracted prior to moving the tow vehicle.
B
A
Fig.41
Fig.43
lci1.com
A
Fig.42
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)

C-Jacks Manual Override

NOTE: For ease of manual override it is recommended to
unplug the power harness to the motor prior to performing
the manual override procedure.
NOTE: Use of a 12-18 volt cordless screw gun or
pneumatic screw gun is acceptable to manually override
the jacks. Do NOT use an impact screw gun to perform any
of the override procedures, as this may damage the motor.
If manual override is necessary there are two options; Jack
Motor Override and Jack Manual Override Nut.
Jack Motor Override:
3/8
Tools needed: " drive ratchet and extension (no socket)
1. Find the port on the jack gearbox (Fig.44A).
2. Remove the rubber plug (Fig.44A).
3/8
3. Insert the
" drive ratchet and extension into the port.
4. Turn the override until the jack extends or retracts to
desired position.
Fig.44
31
CCD-0002700
TT
®
®
(3K-5K)
A
Rev: 03.02.21