Power Tongue Jack Operation; Connecting To Tow Vehicle; Unhitching From Tow Vehicle - Lippert Components Ground Control TT Installation And Owner's Manual

Power Tongue Jack Operation

NOTE: The ON and OFF switch (Fig.29A) controls the
Power Tongue Jack's light only. If left on for an extended
period of time, the light will drain the trailer's battery.
A
Fig.29
NOTE: The Power Tongue Jack is designed for vertical
movement of the trailer only.

Connecting to Tow Vehicle

1. Chock the tires of the trailer.
2. Press EXT (Fig.29C) if needed to allow the coupler
to clear the hitch ball.
3. Push RET (Fig.29B) to retract the Power Tongue Jack
until the coupler properly mounts the hitch ball.
4. Latch the tow vehicle hitch and connect any wires,
chains or sway control that may be equipped between
the tow vehicle and trailer.
5. Press RET two times and hold on the 3rd time
approximately five seconds until the Power Tongue Jack
stops. Release the switch and the Power Tongue Jack
will automatically retract.
NOTE: Make sure the leg of the Power Tongue Jack
(Fig.30A) is fully retracted prior to moving the tow vehicle.
lci1.com
B
C
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
A
B
Fig.30

Unhitching from Tow Vehicle

1. Prior to unhitching from the tow vehicle, make sure the
trailer is parked on a level surface and chock the tires of
the trailer.
2. Make sure the footpad of the Power Tongue Jack is
pinned securely in place with the clevis pin and hairpin
cotter pin (Fig.30B).
3. Disconnect any wires, chains, or sway control that may
be equipped between the tow vehicle and the trailer.
4. Push EXT (Fig.29C) two times holding on the 3rd time
approximately five seconds, then release the switch
and the Power Tongue Jack will automatically extend to
the ground.
5. Push EXT until the coupler clears the hitch ball.
6. Disconnect the trailer wire connection at the tow vehicle,
if not previously completed.
7. Move the tow vehicle away from the trailer.
8. Push RET (Fig.29B) as needed to return the front of the
trailer to level or use the Auto Level function to level the
trailer. See Auto Leveling Control Touch PAd Operation
and OneControl Touch Panel Operation sections.
16
CCD-0002700
TT
®
®
(3K-5K)
Rev: 03.02.21