GE Consumer & Industrial
Multilin
ACTUAL
STORE
SETPOINT
RESET
MESSAGE
RUNNING
RELAY A
RELAY A
STOPPED
RELAY B
RELAY B
VALUE
AUX RELAY 1
AUX RELAY 1
TRIPPED
ALARM
AUX RELAY 2
AUX RELAY 2
AUTO
MANUAL
STOP
START
START
START
START
A
A
B
B
1.1.1
Description
1.1.2
Features
MM3 MOTOR MANAGER 3 – INSTRUCTION MANUAL
MM3 Motor Manager 3
Chapter 1: Introduction
Introduction
1.1
Overview
The MM3 Motor Manager 3 combines control functions normally found in a low voltage
motor control center (MCC) with motor protection. This compact, microprocessor based
device, provides sophisticated control and protective relaying at significant cost savings
over an MCC design using discrete devices.
Standard features simplify maintenance and plant expansion. One MM3 Motor Manager 3
is required for every starter unit in the MCC. The contactor can be energized and de-
energized using the MM3 Motor Manager 3's direct-wired inputs or via the serial port. Full
voltage non-reversing, full voltage Reversing, two-speed, autotransformer, inverter, wye-
delta, slip ring, and part winding type starters may be completely controlled by the MM3
Motor Manager 3 using the two contactor outputs.
Motor protection is included for the most common causes of failure to prevent costly
shutdowns and rewinds. These include three-phase overload, stalled rotor, ground fault
and loss of phase.
A two-wire RS485 Modbus communications port is provided for high speed
communications with a complete line-up of MCCs. Any MM3 Motor Manager 3 may be
interrogated on demand to determine both actual and setpoint operating parameters.
Fast response time to a request for alarm or trip status makes real time control of a
complete process possible. Statistical recording of running hours and number of starts and
trips assists with predictive maintenance scheduling.
The MM3 Motor Manager 3 has been developed with economy in mind. The customer is
able to choose from different options to achieve maximum benefit from the relay when
integrated into the process environment. The standard MM3 Motor Manager 3 comes with
1–1
Need help?
Do you have a question about the Multilin MM3 Motor Manager 3 and is the answer not in the manual?