Process Options - GE Multilin MM3 Motor Manager 3 Instruction Manual

S3 PROCESS
5.4.6 Process
Options

] PROCESS OPTIONS

]
5–30
• "REAL POWER": Specified by the
setpoint. with a maximum setting of 1000 kW. The range is from 0 to
MOTOR RATING
the value.
MOTOR RATING
• "FORCED OUTPUT": The user can force the analog output from 0 to 100% of full-scale.
The
ANALOG OUTPUT FORCE
OUTPUT".
PATH: S3 PROCESS PROCESS OPTIONS
The process options settings are programmed as follows:
• MANUAL/AUTO KEYS: When set to "Enable", the user can change to control mode
from the keypad to either manual or auto. When set to "Disable", the unit is considered
to be in both manual and auto mode, and will accept start commands from the
faceplate, switch inputs, and over the serial link.
• START A KEY and START B KEY: When set to "Enable", the user can start the motor with
the START A or START B key when the motor status is available to start and the MM3
Motor Manager 3 is in Manual mode. When set to "Disable", any START A or START B
keypress is ignored.
• START KEY MODE: When set to "Normal", the START A/B keys operate as described in
Start A/B Keys on page 3–5. When set to "Test Only", the START A/B keys will only be
recognized when the unit is in test mode. To be in test mode, one of the interlock
inputs must be programmed as "TEST" and energized.
• STOP SWITCH INPUT: When set to "Enable", any opening of the stop switch input while
the motor is running causes the motor to stop. When set to "Disable", any stop
command received on the stop switch input will be ignored.
S1 CONFIGURATION
setting is seen only if the
ANALOG OUTPUT TYPE
MANUAL/AUTO KEYS:
ENABLE
START A KEY:
ENABLE
START B KEY:
ENABLE
START KEY MODE:
NORMAL
STOP SWITCH INPUT:
ENABLE
MM3 MOTOR MANAGER 3 – INSTRUCTION MANUAL
CHAPTER 5: SETPOINTS
MOTOR IDENTIFICATION
is "FORCED
Range: ENABLE, DISABLE
Range: ENABLE, DISABLE
Range: ENABLE, DISABLE
Range: NORMAL, TEST ONLY
Range: ENABLE, DISABLE