Connecting Other Devices - Panasonic VL-V900 Installation And Operating Instructions Manual

4.6 Connecting other devices

4.6.1 Connecting electric locks
An electric lock can be connected to the electric lock connection terminal located on the rear of the lobby station
(page 12).
R One electric lock can be connected to each lobby station.
R After connecting an electric lock to the lobby station, confirm that the door can be properly locked and unlocked
using the main monitor.
4.6.2 Connecting to a PBX
The control box can be connected to a Panasonic PBX. Use the RJ11 jack located on the side of the control box
(page 13) to connect it to an analogue extension port of the PBX. Consult your certified Panasonic dealer for more
information.
R The control box can be connected to only one PBX.
R For information on how to connect extensions telephones to the PBX, see the operating instructions included with
the PBX.
– 4 extension numbers of the PBX can be registered with the control box for use by facility staff, receptionists,
etc.
– One extension number of the PBX can be registered with the control box for use as the emergency terminal.
R If a digital PBX is used, system software for digital PBXs must be downloaded and installed to the control box.
– Download information is available at the following web site.
http://panasonic.net/pcc/support/intercom/v900
– Refer to 5.8 Upgrading the system software for digital PBXs (Page 57) or consult your certified Panasonic
dealer for information about upgrading the system software.
4.6.3 Connecting to lifts
A lift can be connected to the lift connection terminals located on the side of the lift controller (page 14). For information
on how to connect lifts to the lift controller, refer to the operating instructions included with the lift.
R Up to 3 lifts can be controlled.
4.6.4 Connecting cameras
A camera can be connected to the coaxial connector located on the rear of the lobby station (page 12).
R One camera can be connected to each lobby station.
R Compatible cameras:
– Cameras that support PAL or NTSC video signals. Consult your certified Panasonic dealer for more
information.
4.6.5 Connecting a TV monitor
A TV monitor can be connected to the coaxial connector located on the side of the control box (page 13).
R One TV monitor can be connected to the control box.
R Note that the control box can only output NTSC video signals to the TV monitor.
R Compatible TV monitors:
– TV monitors that support NTSC video signals. Consult your certified Panasonic dealer for more information.
4. Installation
37