Appendix C Configuring Sata For Raid; Configuring Sata Hard Drive(S) For Raid (Controller: Intel Q370/C246) - AXIOMTEK SHB150R Series User Manual

SHB150R LGA1151 Full-size CPU Card
Appendix C
Configuring SATA for RAID
C.1 Configuring SATA Hard Drive(s) for RAID (Controller:
®
Intel Q370/C246)
Before you begin the SATA configuration, please prepare:
Two SATA hard drives (to ensure optimal performance, it is recommended that you use two
hard drives with identical model and capacity). If you do not want to create RAID with the SATA
controller, you may prepare only one hard drive.
Please follow up the steps below to configure SATA hard drive(s):
1. Install SATA hard drive(s) in your system.
2. Enter the BIOS Setup to configure SATA controller mode and boot sequence.
3. Configure RAID by the RAID BIOS.
1. Installing SATA hard drive(s) in your system.
Connect one end of the SATA signal cable to the rear of the SATA hard drive, and the other end
to available SATA port(s) on the board. Then, connect the power connector of power supply to
the hard drive.
2. Configuring SATA controller mode and boot sequence by the BIOS Setup.
You have to make sure whether the SATA controller is configured correctly by system BIOS
Setup and set up BIOS boot sequence for the SATA hard drive(s).
58 Configuring SATA for RAID