Free-Standing Installation; Connecting The Hub To The Power Source - Cabletron Systems MRX Installation Manual

INSTALLATION

3.3.3 Free-Standing Installation

For a free-standing installation, locate the HUB within 7 feet of its
power source and with an unrestricted free surface area 21 inches
wide, 18 inches deep and 6 inches high.
Figure 3-6. Shelf or Table-top Installation

3.4 CONNECTING THE HUB TO THE POWER SOURCE

Connect the HUB to the power source as follows:
NOTE: The HUB has a universal power supply. This allows you to
connect the HUB to power sources from 85 Vac to 264 Vac, 47-63Hz.
1. Plug the power cord (see Figure 3-6) into the power receptacle
located on the rear of the HUB.
2. Plug the power cord into a grounded wall outlet.
After you have made the power connection, verify that the POWER
LED is lit, indicating that the HUB is receiving power.
Page 3-8