External Connection - KYOWA DPM-900 Series Instruction Manual

5-13-2 External Connection

When remote controlling the DPM-900/950 series, use the terminals of the centralized connector. Perform
wiring after removing the housing from the centralized connector. For details of the centralized connector,
read "5-12 APPLICATION OF THE CENTRALIZED CONNECTOR."
NOTE
An AC power supply is also connected to the centralized connector. Therefore, be sure to remove
the power plug from the AC outlet.
Shown at the right are the recommended circuits for
remote control.
If a circuit other than shown is used, contact
KYOWA or our representatives.
Remote Control Signal Input
Direct Contact Input
COM
Remote Control Signal Input
Contact Input via Buffer
COM
Take care of chattering due to switching.
29
Switch
+5V
C
1000p
Switch
HC14
R
10 kohm