KYOWA DPM-900 Series Instruction Manual page 58

9-6 INTERNAL GAIN AND INPUT STRAIN
【BV = 2 Vrms】
Internal
Gain
Input strain ［ ］
× 200
× 2000
× 20000
【BV = 0.5 Vrms】
Internal
Gain
Input strain［ ］
× 200
× 2000
× 20000
NOTE
The higher the setting value of the VOLTAGE OUT switch, the greater the sensitivity adjustment
accuracy. So it is recommended to set the range from 1.00 to 10.00.
If the value of the VOLTAGE out switch is less than 1.00 , it may not satisfy the specifications
for sensitivity adjuster accuracy.
In addition, setting that expanded for input strain range within ±200000 µm/m at BV=0.5 Vrms is
possible. In that case, refer to table above to set the range from "00.10" to "10.00."
For other details about sensitivity fine adjustment, refer to "4-6-5 Sensitivity Fine Adjustment."
Switch Setting
Output voltage ［V］
5000
5000
500
Switch Setting
Output voltage ［V］
2000
2000
2000
Sensitivity fine
adjustment × 1
1.00 ±50000
10.00 ±5000
10.00
Sensitivity fine
adjustment × 1
0.10 ±200000
1.00 ±20000
10.00 ±2000
53
Input Range［ ］
〜
adjustment × 1/2.5
〜
〜
±500
〜
Input Range ［ ］
〜
adjustment × 1/2.5
〜
〜
〜
Sensitivity fine
±125000
±12500
±1250
Sensitivity fine
±500000
±50000
±5000