Tpn/Dlt Measuring Mode （For The Dpm-911/951 Only - KYOWA DPM-900 Series Instruction Manual

5-15 TPN/DLT MEASURING MODE （For the DPM-911/951 only）
In addition the strain gages or strain gage transducers, the DPM-900/950 series can measure data using
Rotary Transformer Torque Transducer, and Inductance-Type Displacement Transducer.
Be sure to change modes to the TPN/DLT Measuring Mode for using the Rotary Transformer
Torque Transducer or Inductance-Type Displacement Transducer.
To change modes to the TPN/DLT Measuring Mode, turn ON the Setting Switch 4 on the rear panel. Be
sure to turn OFF the DPM-900/950 series before changing the Setting Switches.
In addition, for how to set the internal gain, read 5-7 INTERNAL GAIN.
NOTE
Turn ON the "Setting Switch 4" and immediately after turning ON the power, check that the monitor
display changes as follows.
All LED light up ® Version of the built-in software ® '
® Output voltage
The
Do not conduct the bridge check function with the Rotary Transformer Torque Transducer
connected.
If the "Setting Switch 4" of the DPM-912/913/952 is turned ON, the DPM-912/913/952 is still in
the Normal Mode.
MEMO
After turning ON the DPM-900/950 series, press and hold the SET switch for checking the TPN/DLT
Measuring Mode.
The following display appears on the monitor.
The version of the built-in software and
Press and hold the SET switch if the Setting Switch 4 is set to OFF.
The following display appears.
The version of the built-in software is scrolled horizontally.
appears in the TPN/DLT Measuring Mode only.
'（Scroll horizontally）
are scrolled horizontally.
31