Using Setup; Getting Help; In Case Of Problems; A Final Note About Setup - Contec IPC Series User Manual

5. BIOS Setup

Using Setup

In general, you use the arrow keys to highlight items, press <Enter> to select, use the PageUp and
PageDown keys to change entries, press <F1> for help and press <Esc> to quit. The following table
provides more detail about how to navigate in the Setup program using the keyboard.
Table 5.1. Using Setup
Key
Up Arrow
Down Arrow
Left Arrow
Right Arrow
ESC
Move Enter
+ Key
- Key
F1 Key
F2 Key
F3 Key
F4 Key
F5 Key

Getting Help

Press F1 to pop up a small help window that describes the appropriate keys to use and the possible
selections for the highlighted item. To exit the Help Window press <Esc> or the F1 key again.

In Case of Problems

If you cannot boot the computer after using Setup to change and save system settings, the computer will
have to be repaired. It is safest not to change system settings you do not fully understand. Therefore, it is
strongly recommended that you do not change any of the default settings for the chipset. These defaults
have been selected with sufficient consideration by the AMI and system manufacturers to ensure
maximum performance and reliability. Even changing the chipset settings slightly can result in an
unavoidable need for repairs.

A Final Note About Setup

The information in this chapter is subject to change without notice.
36
Move to the previous item
Move to the next item
Move to the item on the left (menu bar)
Move to the item on the right (menu bar)
Main Menu: Quit without saving changes
Submenus: Exit Current page to the next higher level menu
Move to the item you desired
Increase the numeric value or make changes
Decrease the numeric value or make changes
General help on Setup navigation keys
Load the previous settings.
Load the defaults of Windows 7 from the BIOS default table.
Save all the changed settings to the FLASH ROM and exit
Load the defaults of Windows 10 from the BIOS default table.
Function
PT-956SxX Series User's manual