EWM BUSINT X11 Operating Instructions Manual page 67

Actuation data
Byte Bit no.
no.
1 4
1 6
1 7
2 0-3
2 7
3 0-7
4 0-7
5 0-7
6 0-7
7 -
8 0-7
9 -
Item No.: 099-008225-EWM01
Profiles for PHOENIX MIG/MAG systems
Function
Position search
Bit allocation:
0
1
Bit allocation:
0
1
Check monitoring function
Bit allocation:
0
1
Welding simulation
Bit allocation:
0
1
Program number specification Select a program number in the range 0-15
Specification of master power
source with TANDEM
systems (optional)
Bit allocation:
0
1
JOB number specification
WF specification, high-byte
WF specification, low-byte
Correction specification,
high byte
Correction specification,
low byte
Dynamics specification,
high byte
Dynamics specification,
low byte
Profiles for the Profibus DP module
Description
Activates the position search function for the
workpiece
Position search off
Position search on
Manual check via the blow-out valve
Blow-out valve off
Blow-out valve on
Activate/deactivate welding parameter monitoring
Monitoring deactivated
Monitoring activated
Activates the Simulate Welding function
Simulation off
Simulation active
Activates the master/slave power source in a
TANDEM system
System adopts slave function
System adopts master function
Select a JOB number in the range of
1-255
Specify the wire speed in program 0
Range: 0 to 0 x 7FFF
0 corresponds to WF-MIN
0 x 7FFF corresponds to 25.0 m/min
Specify the wire speed in program 0
Specify the voltage correction in program 0
Range: 0 to 0 x 7FFF
0 corresponds to -10.0 V
0 x 4000 corresponds to 0 V
0 x 7FFF corresponds to +10.0 V
Specify the voltage correction in program 0
Specifies the dynamic in program 0
Range: 0 to 0 x 7FFF
0 corresponds to -40
0 x 4000 corresponds to 0
0 x 7FFF corresponds to +40
Specifies the dynamic in program 0
67