Table of Contents
Advertisement
Device maintenance and repair
7.4 Installing the software
Information for systems with RAID or AHCI controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program.
Requirement
You have copied the relevant controller driver to a USB stick.
Procedure
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
7.4.6
Installing Hardware RAID controller software
Note
Observe the "General information on commissioning (Page 41)" in section "Commissioning
the device". Additional information is available in section "Installing drivers and software
(Page 96)".
100
Operating Instructions, 03/2021, A5E50259546-AA
SIMATIC IPC1047E
Advertisement
Table of Contents
