Connecting A Single Power Supply; Connecting A Redundant Power Supply - Siemens SIMATIC IPC1047E Operating Instructions Manual

3.3.2.2

Connecting a single power supply

Requirement
• 1 power supply cable
• You have observed the Information about the power supply (Page 38).
• The connecting cables, connectors, sockets and connection materials used meet the
requirements according to section "Country-specific information on supply voltage
(Page 37)".
Procedure
1. Set the on/off switch ① to position '0'.
This prevents the device from starting automatically when
the power supply cable is plugged in.
2. Connect the IEC connector of the power supply cable with the
socket ②.
3. Plug the power cable plug into the power outlet.
4. Set the on/off switch ① to position 'I'.
The power LED to the left of the on/off switch and on the
front panel of the device lights up.
3.3.2.3

Connecting a redundant power supply

Requirement
• 2 power cables
• You have observed the Information about the power supply (Page 38).
• The connecting cables, connectors, sockets and connection materials used meet the
requirements according to section "Country-specific information on supply voltage
(Page 37)".
SIMATIC IPC1047E
Operating Instructions, 03/2021, A5E50259546-AA
Installing and connecting the device
3.3 Connecting the device
39