Changing A Backplane For Removable Tray - Siemens SIMATIC IPC1047E Operating Instructions Manual

Expanding and assigning parameters to the device
6.5 Drives
6.5.2.4

Changing a backplane for removable tray

The backplane is installed from inside at the back end of the drive cage type A and is
equipped with interfaces for data cable to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Requirement
• An original spare part, that is a backplane approved for this device, see notes in section
"Accessories and spare parts (Page 20)".
• The device is fully disconnected from the line voltage, see section "Switching off the
device (Page 43)".
• The device is open; see section "Open the device. (Page 53)".
Procedure
1. Note the assignment of all data cables to the motherboard and disconnect all data cables ①.
2. Unlock the backplane by pressing firmly in the direction of the arrow on the latching lugs ②
and press the ejector ③.
3. Remove the unlatched backplane board ④ by turning it upwards from the brackets and
removing it from the drive cage.
See also
Installing a backplane for removable tray (Page 68)
70
Operating Instructions, 03/2021, A5E50259546-AA
SIMATIC IPC1047E