Replacing The Hdd Backplane - Fujitsu PRIMERGY RX2450 M1 Upgrade And Maintenance Manual

Installing the new 2.5-inch HDD module
▶ Install the HDD/SSD module, see
on page 85.
Concluding steps
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
7.3.5

Replacing the HDD backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove all HDD/SSD modules, see
module" on page
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
RX2450 M1
Hard disk drive (HDD) / solid state disk (SSD)
"Installing 2.5-inch HDD/SSD modules"
72.
92.
Upgrade and Maintenance Manual
Hardware: 20 minutes
37.
37.
38.
39.
"Removing a 2.5-inch HDD/SSD
"Performing a RAID
95