Replacing A Gpu Card From Riser Module 2 - Fujitsu PRIMERGY RX2450 M1 Upgrade And Maintenance Manual

Figure 112: Installing the slot covers
▶ Install the slot covers and fasten the screws (see circles).
Concluding steps
▶ Install the riser module 2, see
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
9.4.6

Replacing a GPU card from riser module 2

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH1 / (+) No. 1 screw driver
– Phillips PH2 / (+) No. 2 screw driver
The GPU card can only be installed in slot 1 for riser module 2.
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
RX2450 M1
"Installing the riser module 2" on page
44.
48.
49.
37.
Upgrade and Maintenance Manual
Expansion cards and riser cards
Hardware: 10 minutes
37.
57.
139