Switching Off The Id Identicators - Fujitsu PRIMERGY RX2450 M1 Upgrade And Maintenance Manual

Basic software procedures
Using the BIOS
▶ Enter the BIOS.
▶ Select the Configuration menu.
The addresses are displayed at the one or more of the following (it depends on
the behavior of the UEFI driver included in each controller).
1. The addresses are displayed at the UEFI driver menu included in each
controller in the Configuration menu.
2. Select the UEFI driver menu included in each controller. The addresses are
displayed at the help for the UEFI driver menu included in each controller.
3. Enter the Network Device List menu. The addresses are displayed in the
Network Device List menu.
Only network controllers supporting the Command Line Protocol (CLP)
will be displayed.
5.2.8

Switching off the ID identicators

The ID indicators can also be deactivated using IPMI.
Using the ID button on the I/O panel
▶ Press the ID button on the I/O panel to switch off the ID indicators.
For more information, see
74
"Indicators on the I/O panel" on page
Upgrade and Maintenance Manual
210.
RX2450 M1