speed <rate>
Purpose
Use the speed command to specify the data rate for the
your VT100 terminal emulator or emulator software. Use the form of this command to restore
the default value.
Syntax Description
Table 30
displays the syntax description for the speed <rate> command.
Syntax
rate
Default Values
The rate is set to 9600 bps.
Command Modes
The Console Interface Configuration Mode is required for this command.
Usage Examples
Configure the CONSOLE port for 19200 bps.
TA238(config-con 0)#speed 19200
61200630L1-35C
Table 30. Syntax Description for speed <rate>
Description
Rate of data transfer on the interface (2400, 4800, 9600, 19200, 38400, 57600,
or 115200 bps)
Line (Console) Interface Config Command Set
port. This setting must match
CRAFT
69