Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
configure
Purpose
Use the configure command to enter the Global Configuration Mode. Refer to
Configuration Mode Command Set"
Syntax Description
The configure command has no subcommands.
Default Values
The configure command has no default values.
Command Modes
The Enable Mode Command prompt is required for this command.
Usage Examples
Enter the Global Configuration Mode using the following command:
TA238#config
The following response is displayed:
TA238(config)#
The prompt changes as verification that the Global Configuration commands are now
available.
10
on page 30 for more information.
"Global
61200630L1-35C
Advertisement
Table of Contents
