Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
IMA INTERFACE CONFIGURATION COMMAND SET
To activate the IMA Interface Configuration command set, perform the following steps:
1. Enter the Global Configuration Mode using the following command:
TA238#configure terminal
2. Enter the IMA Interface Configuration using the following command:
TA238(config)
The following response is displayed:
TA238(config-ima1)#
The following commands are common to multiple command sets and are covered in a
centralized section of this guide. For more information, refer to the sections listed below:
•
"exit"
on page 76
•
"no"
on page 77
All other commands for this command set are described in this section in alphabetical order.
•
"frame-length <length>"
•
"loopback <option>"
•
"max-diff-delay <option>"
•
"min-active-links <option>"
•
"num-links <option>"
•
"payload-scrambling <option>"
•
"pvc <VPI/VCI>"
•
"tx-id <option>"
•
"version <option>"
46
#
interface ima 1
on page 47
on page 48
on page 49
on page 50
on page 51
on page 52
on page 53
on page 54
on page 55
61200630L1-35C
Advertisement
Table of Contents
