Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
IMA PVC INTERFACE CONFIGURATION COMMAND SET
To activate the IMA PVC Configuration command set, enter the interface ima command at the
Global Configuration Mode prompt; then enter the pvc <VPI/VCI> command at the IMA
Interface Configuration Mode prompt. For example:
TA238#configure
TA238(config)#interface ima
TA238(config-ima)#pvc 0/35
TA238(config-ima-vc0/35)#
The following commands are common to multiple command sets and are covered in a
centralized section of this guide. For more information, refer to the sections listed below:
•
"no"
on page 77
•
"exit"
on page 76
All other commands for this command set are described in this section in alphabetical order.
•
"encapsulation <option>"
•
"ubr+ <peak cell rate> <min cell rate>"
•
"management <option>"
56
on page 57
on page 58
on page 59
61200630L1-35C
Advertisement
Table of Contents
