Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
SHDSL INTERFACE CONFIGURATION COMMAND SET
To activate the SHDSL Configuration command set, perform the following steps:
1. Enter the Global Configuration Mode using the following command:
TA238#configure
2. Enter the SHDSL Interface Configuration using the following command:
TA238(config)#interface shdsl
The following response is displayed:
TA238(config-shdsl)#
The following commands are common to multiple command sets and are covered in a
centralized section of this guide. For more information, refer to the sections listed below:
•
"no"
on page 77
•
"exit"
on page 76
All other commands for this command set are described in this section in alphabetical order.
•
"annex <type>"
on page 61
•
"loop-attenuation <threshold>"
•
"rate <rate>"
on page 63
•
"snr-margin <threshold>"
•
"termination <option>"
60
on page 62
on page 64
on page 65
61200630L1-35C
Advertisement
Table of Contents
