Port (Port Configuration); Interface; Ts0 Rate; Mapping - ADTRAN ESU LT User Manual

Port (Port Configuration)

Interface

TS0 Rate

Mapping

61200410L2-1A
TS0
Selects a full 56/64K TS0 as the management channel. The
management channel is automatically allotted to the first active
TS0, and the DTE clock rate decreases by either 56K or 64K
(depending on the Nx configuration). For example, on a full E1
circuit with TS0 management enabled, channel 1 is the
management channel and the DTE clock rate will drop from 1984K
to 1920K.
On a fractional E1 with channels 3 and 4 mapped and TS0
management enabled, channel 3 will be the management channel
and the DTE clock rate would drop from 128K to 64K.
TS0 management is not available in unframed mode.
The menu item P
ORT
parameters associated with the high-speed serial interface.
This option sets the electrical interface for the Nx56/64 port.
This sets the base rate of the interface. The actual data rate depends
on the number of time slots used.
Choices: 56K; 64K
This sets the unit to use alternate or contiguous channels in the E1
data stream. If more than 16 channels are used in CCS mode,
contiguous must be used. If more than 15 channels are used in CAS
mode, contiguous must be used. If other than a private network is
used, the carrier must be notified of this choice.
Choices: ALT (alternate); CONT (contiguous)
ESU LT User Manual
Chapter 5. Configuration Menu
is used to select and then to configure the
49