Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
stopbits <option>
Purpose
Use the stopbits <option> command to set the number of stop bits per character for a terminal
session. This value must match the configuration of your VT100 terminal or terminal
emulator software. The default is 1 stop bit per character. Use the no form of this command to
return to the default value.
Syntax Description
Table 31
displays the syntax descriptions for the stopbits <option> command.
Table 31. Syntax Description for stopbits <option>
Syntax
1
2
Default Values
The stopbits option is set to 1 stop bit.
Command Modes
The Console Interface Configuration Mode is required for this command.
Usage Examples
Configure 2 stop bits per character for the console terminal session.
TA238(config-con 0)#stopbits 2
70
Description
1 stop bit
2 stop bits
61200630L1-35C
Advertisement
Table of Contents
