Table of Contents
Advertisement
Total Access 238 Command Line Interface Guide
show interfaces ethernet
Purpose
Use the show interfaces ethernet command to display information on the IEEE 802.3 port.
Syntax Description
The show interfaces ethernet command has no subcommands.
Default Values
The show interfaces ethernet command has no default values.
Command Modes
The Enable Mode Command prompt is required for this command.
Functional Notes
The following is a list of output examples from this command:
• Link Status (up/down)
• MAC address
• Number of:
– packets input/output
– TX/RX errors
– alignment errors
– CRC errors
– RX collisions
– single/multiple/excessive collisions
– deferred packets
– carrier-sense errors
Usage Examples
Show the Ethernet configuration/status/performance related information.
TA238#show interfaces ethernet 1
20
61200630L1-35C
Advertisement
Table of Contents
