Table of Contents
Advertisement
speed <rate>
Purpose
Use the speed <rate> command to configure the speed of an Ethernet interface. Use the no
form of this command to return to the default value.
Syntax Description
Table 18
displays the syntax descriptions for the speed <rate> command.
Syntax
10
100
This command should only be used if autonegotiation is disabled
(using the no autonegotiation command). Using autonegotiation
allows the Ethernet interface to automatically configure the speed
and duplex. If the speed is manually set to 10 or 100, the duplex
must be manually configured as duplex full or duplex half.
Default Values
No defined rate; autonegotiation is on by default.
Command Modes
The Ethernet Interface Configuration Mode is required for this command.
Usage Examples
The following example configures the Ethernet port for 100 Mb operation:
TA238(config-eth)#speed 100
61200630L1-35C
Table 18. Syntax Description for speed <rate>
Description
10 Mb Ethernet
100 Mb Ethernet
Ethernet Interface Configuration Command Set
NOTE
45
Advertisement
Table of Contents
