Table of Contents
Advertisement
LINE (TELNET) INTERFACE CONFIG COMMAND SET
For the Line (TELNET) Interface Configuration command set main page use the following:
To activate the Line (TELNET) Interface Configuration command set, perform the following
steps:
1. Enter the Global Configuration Mode using the following command:
TA238#configure
2. Enter the Line (Telnet) Interface Configuration using the following command:
TA238(config)#line telnet
The following response is displayed:
TA238(line-telnet)#
The following commands are common to multiple command sets and are covered in a
centralized section of this guide. For more information, refer to the sections listed below:
•
"no"
on page 77
•
"exit"
on page 76
All other commands for this command set are described in this section in alphabetical order.
•
"port <option>"
on page 72
•
"shutdown"
on page 73
61200630L1-35C
Line (Telnet) Interface Config Command Set
71
Advertisement
Table of Contents
