ADTRAN jobAid+ 1200482G1 Manual

Product P/N: 1200482G1
Documentation for ADTRAN Access and Aggregation products is
available for viewing and download directly from the ADTRAN Support
Community website.
Go to: https://supportforums.adtran.com/welcome
Registration is required.
ADTRAN offers training courses on our products, including customized
training and courses taught at our facilities or at customer sites.
For inquiries, go to: http://adtran.com/training
D
ESCRIPTION
The 2.5 Gbps Multimode SFP plugs into ADTRAN GigE modules
designed to accept SFPs. The SFP provides an optical interface to
the GigE physical interface. Installed into an appropriate host
module, the SFP provides a GigE interface to the supporting
system.
NOTE
To ensure compatibility, refer to the documentation provided
with the host module.
The following features are supported on the SFP:
■ Tri-Rate 1.063/2.125/4.25 Gbps, 850 nm, multi-mode, 2 fiber
operation
■ Maximum Optical distance: see table below.

Maximum Optical Distance Table

Data Rate OM3 MMF
1.062 Gbps 860m
2.125 Gbps 500m
4.25 Gbps 380m
!
CAUTION
Due to compliance certification requirements, only SFPs supplied
by ADTRAN are to be used with ADTRAN modules. ADTRAN
cannot certify system integrity with other SFPs.
Small Form-factor Pluggable
2.5 GBPS MULTIMODE SFP
The following related online documents and resources provide additional information for this
product:
SFP/XFP/SFP+ Compatibility Matrix (online tool, go to: http://www.adtran.com/sfp)
OM2 MMF OM1 MMF
550m 300m
300m 150m
150m 70m

Specifications

■ Optical Specifications:
♦ Optical transmit level: –2.5 dBm to –9.0 dBm
♦ Optical receive level:
● 1.062 Gbps, –3.0 dBm to –15.0 dBm
● 2.125 Gbps, –3.0 dBm to –13.0 dBm
● 4.25 Gbps, –3.0 dBm to –12.0 dBm
♦ Link power budget: 6.0 dB
♦ Optical connectors: LC
I
NSTALLATION
Before installing the equipment, inspect the SFP. If damage has
occurred during shipping, file a claim with the carrier, and then
contact ADTRAN Customer Support. For more information, refer
to the warranty.
To install the SFP into an appropriate module, complete the
following steps:
NOTE
Do not remove the protective end cap from the SFP until you are
ready to connect the fiber optic cable.
1. Insert the SFP into the SFP cage on the module. Ensuring
that the latch handle on the SFP is facing upward, slide the
SFP all the way into the SFP cage until there is an audible
"click".
NOTE
The latch on the SFP is for removal only. When removing the SFP,
rotate the latch away from the SFP, the SFP should easily slide out
of the cage.
2. Remove the end cap and connect the fiber to the SFP+.
NOTICE
We recommend that you keep the protective end cap on
whenever the transceiver optical fiber connector is not in use.
3. Continue the installation and turn-up of the host module
using the instructions in the Job Aid provided with the
module or other system-level documentation available
online at www.adtran.com.
jobAid
Issue Date: March 2016
Document P/N: 61200482G1-22A