Table of Contents
Advertisement
BEND CONFIGURATIONS
Return Bends
Hem
Stiffening Rib
BENDING EXAMPLES
Folding Over a Lip
The thickness, width, and length of material are factors to
consider when folding a lip. DO NOT exceed 20ga. (.035")
for material thickness.
1. With the clamping bar in place and properly secured,
bend the material as far as the bending leaf will allow.
(Normal bending procedure)
2. Now remove the clamping bar, bring up the bending leaf, and
continue the fold as in (fig. 12). (No clamping is required.)
3. To further flatten the material, slide the piece part forward
about 1/2" and use the bar to magnetically clamp it as shown
in (fig. 13)
Rolled Edge
Closed Channel
Angle Bend
24
24
Box
Fins
figure 12
figure 13
Advertisement
Table of Contents
