Spot View - Nuvico Xcel D-PL800 User Manual

DVR User Manual
Live View Introduction
Check "Dwell" and then set scheme view in sequence of the adjuvant output. The setting steps
are similar to that of the main output.
Set quick sequence view if "Dwell" is not checked. The setting steps are as follows:
① Set screen mode by clicking the relevant buttons on the tool bar.
② Select one window and then double click one camera or group in the list.
③ Click "Apply" to save the settings after adding cameras or groups to the windows.

5.2.4 Spot View

Click StartSettingsSystemBasicOutput SettingsSecondary Output/Output 2 to go to
the interface as shown below.
Click on the left to create a new scheme. Each scheme can only add one analog camera.
Select a scheme on the left and then double click or drag a camera on the right to the scheme
window in the middle of the interface. After finishing the settings of all the schemes, select the
dwell time and click "Apply" to start playing the schemes in sequence in output 2.
33