Upnp Configuration; Nat Configuration; Ftp Configuration; Platform Access - Nuvico Xcel D-PL800 User Manual

Table of Contents

Device Management

11.1.6 UPnP Configuration

By UPnP you can access the DVR through the web client which is in WAN via router without

port mapping.

① Click StartSettingsNetworkUPnP to go to the following interface.

② Make sure the router supports UPnP function and the UPnP is enabled in the router.

③ Set the DVR's IP address, subnet mask and gateway and so on corresponding to the router.

④ Check "Enable" in the interface as shown below and then click "Apply".

Click "Refresh" to refresh the UPnP status. If the UPnP status were still "Invalid UPnP" after

refreshing it for many times, the port number would be wrong. Please change the mapping type

to "Manual" and then click

UPnP". Refer to the following picture. You can view the external IP address of the DVR. Enter

the external IP address plus port in the address bar to access the DVR such as

http://183.17.254.19:81.

Click StartSettingsNetworkNAT to go to the interface for NAT configuration. Check

"Enable" and then select the NAT server address. Click "Apply" to save the settings.

You can scan the QR Code through mobile APP on your mobile phone or tablet to log into the

recorder instantly.

Some models may not support this function.

Click StartSettingsNetworkFTP to go to the interface for FTP configuration. Check

"Enable" and enter the server name, port, username and password, max file size and remote

directory.

11.1.9

Some models may not support this function.

This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows.

to modify the port until the UPnP status turns to "Valid

101

DVR User Manual

Table of Contents